Section 2: Installation
Page 10
2.3 Ventilation
Requirements
The air supply to this appliance must conform to the relevant regulations and the minimum effective
air requirement for this appliance is 65 cm
2
.
All air vents fitted direct to the outside of the building should be fire proofed, sealed to prevent the
ingress of moisture and fitted as specified by the relevant local & national regulations.
If there is another appliance using air fitted in the same or adjacent room, the minimum air
requirement will need be recalculated.
On completion of the installation a spillage test should be conducted with all other air using
appliances operating at full rate.
2.4
Pre-Installation Assembly
The following procedure should be followed to assembly the cooker before it is positioned in its final
installation position (refer to the exploded view in section 4 for part number references):
1.
Remove the outer packaging from the unit and remove the packaging strip from the side of the cooker.
2.
Remove the back heat shield (77) from the unit by removing the four hex head self tapping screws (two
on each side). Remove all the loose components from the top of the cooker, the firebox & the oven (see
Figure 2.9). Remove the three doors (2, 3 & 57) by lifting them off the hinge pins on the front casting
(1)
Figure 2.9
3.
Place a set of supports, approximately 18” high and sufficiently strong enough to support the weight of
the cooker, behind the cooker and tilt the cooker backwards so as to lay the back of the cooker on the
supports as shown in Figure 2.10.
4.
Fit the four legs (36) to the four corners of the base casting (13) using the four M10 x 20mm hex head
bolts & washers.
5.
Lift the cooker off the supports onto the legs taking care not to put excess pressure on the legs.
6.
Join the two sections of the front plinth (37 & 38) together by screwing the name plate (51) into position
between the two sections using the back fixing strip (54) and the two ¼” x 1 ¾” countersunk screws
with nuts.
7.
Fit the complete skirting under the front of the cooker inside the front legs using the ¼” x ¾” round head
screws and nuts (see Figure 2.11).
