203729
Rev. E, 11/20/18
© 2018, THE STANLEY WORKS. ALL RIGHTS RESERVED.
4 of 18
3.
INSTALLATION INSTRUCTIONS
NOTE
These instructions are intended to supplement the other installation instructions supplied with this package.
3.1
Installing the Header and Jambs
3.1.1
Refer to Stanley Access Technologies document No. 203590, “Dura-Glide
2000
Installation Manual,” and INSTALL the header and jambs.
3.2
Installing the Top and Bottom Rails onto the Glass Panel
WARNING
To prevent injury, two people are required to lift and handle the glass panels.
To prevent damage to the glass panels from scratching, saw horse working surfaces should be protected
with carpeting or some other soft material.
NOTE
The instructions for installing the top and bottom rails onto the glass are the same for the O panels and SX
panels.
3.2.1
Refer to Figure 2, and
carefully
POSITION glass panel onto saw horses.
3.2.2
INSTALL rubber gasket onto top of glass panel, and ENSURE the following:
•
Rubber gasket is centered along the width of the glass.
•
Rubber gasket is fully seated against the top of the glass.
•
Tech Tip: Use painter’s tape to keep rubber gasket in place.
3.2.3
With flat side of wedge facing upward, SLIDE wedge into side of rail.
3.2.4
SLIDE plate into side of rail.
3.2.5
With flat side of rail facing upward, POSITION rail over rubber gasket and glass
panel.
3.2.6
INSTALL, but do
not
tighten ¼ -20 X
5
/
8
″
cap screws into bottom of rail and plate.
3.2.7
ALIGN rail onto glass so that the leading edge of the glass butts against the end cap.
3.2.8
While pushing rail down and toward bottom edge of glass,
evenly
TORQUE ¼ -20 X
5
/
8
″ cap screws to
80 in-lbs
. REMOVE or TRIM painter’s tape as needed.
3.2.9
REPEAT Section 3.2 for each rail on O and SX panels.
