203729
Rev. E, 11/20/18
© 2018, THE STANLEY WORKS. ALL RIGHTS RESERVED.
10 of 18
3.7.7
Locate the gray self-adhesive pile from the hardware kit and cut to length. Peel the
self-adehsive backing and PRESS on the pile to the trail edges of the O shoes. ALIGN
the pile so it contacts the jambs when the panels are in the closed position.
3.8
Adjusting
the SX Panels
3.8.1
Refer to Figure 5, and ADJUST SX panel height as follows:
a.
LOOSEN the nuts securing the upper load wheels to the hanger.
NOTE
Each load wheel is an eccentric that permits adjustment of the threshold/track-to-panel gap. The total
adjustment available from the load wheels is approximately
5
/
16
”.
b.
Using an Allen wrench, TURN the load wheels until the following occur:
•
Threshold/track-to-panel gap is even across the entire bottom of the door
panel.
•
The stiles of both door panels meet and are parallel with no gap at the top or
bottom.
c.
WHEN adjustment is complete, TIGHTEN nuts securing load wheels to hanger.
NOTE
The anti-riser adjustment is performed to prevent the door panel from moving upward. The anti-riser track
serves as a roller surface for the anti-riser wheels.
3.8.2
ADJUST the anti-risers as follows:
Figure 7. Weatherstripping Installation
