SSS-SEDA (Emergency Door Alarm)
Installation Instructions
NOTE:
SEDA Door Sensors are provided to match the door width provided.
INSTALLATION INSTRUCTIONS:
FULL MORTISE HINGE
See Separate sheet provided for installation instructions.
POWER SUPPLY / CONTROLLER
Install the Power Supply / Controller. Connect console to it. Power up the controller.
All LED’s should turn green. Install each door individually as follows
STROBE
Mount on ceiling and run wires to Controller.
Observe Polarity Red “+” and Black “-“.
KEY SWITCH
Add mortise cylinder (straight Yale cam).
Mount on single gang box at door and run wires to Controller. Key switch is “NC”, system can not work without it.
DOOR SENSOR
Please Read Completely Before Starting
1) Mark a horizontal line ¾” from the top of the door and extend to
the lock edge of the door as shown in .
2) Mark a vertical line 1-1/8" from the notched edge of the hinge as
shown in .
3) Mark center point at horizontal and vertical line intersects. Drill
pilot hole of 1/8" as shown in .
4) Loosen sensor cover screws enough to enable removal of the sensor cover form the mounting plate.
Loosen sensor adjustment nuts.
5) Place sensor mounting plate on the door with first mounting hole over pilot hole as shown in . Pull
out wire from wiring hole.
6) Temporarily secure the hinge side sensor mounting plate on door with two self-tapping / wood screws as
shown
in .
7) Loosen adjustment nuts on mounting plate and Slide the sensor mounting plate towards the lock edge of
the door so that there is no more than 3/8"-7/16" gap between the sensor mounting plate & the lock edge as
shown in .
8) Line up the cover screws of the sensor cover with
the slots provided on the sensor mounting plate. Adjust the sensor cover as needed. Attach sensor cover
to the mounting plate and loosely tighten the cover screw provided as shown . (Make sure the top
of the cover extends no more than 1/8” above the top of the door).
Test the operation of the sensor.
PULL SIDE OF THE DOOR
Telescoping Sensor
INS SSS-SEDA v6.0.vsd Created: 9/23/2009 Revised:5/27/2010
Page 2
¾”
Horizontal L
ine
Door
Top edge of the door
Frame
Frame
1-1/8"
Not
che
d e
dge
of
the
Hin
ge
Fig-1
Fig-2
Fig-1
Fig-2
Fig-3
Fig-3
Pilot Hole
Fig-4
Fig-4
Sensor Mounting Plate
First Mounting Hole
Door
Door
Self – Tapping / Wood
Screws
Sensor Mounting Plate
Fig-5
Fig-5
Wiring Hole
3/8"-
7/16"
Door
Loc
k Edge of
the Door
Fig-5
Slot Provided
Door
Cover screw
Sensor Cover
Fig-6
Fig-6
