6 of 12
STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
Rev
. 9/2010
Assembly
IMPORTANT:
This unit is shipped without gasoline or oil in the engine. Be
certain to fill the engine with gasoline and oil as instructed before operating
your machine.
Required tools: A Philips head screw driver
1. Remove the chipper from its carton
Remove staples, break glue on top flaps, or cut tape at carton end and peel
along top flap to open carton.
2. Verify all parts in the chipper carton (See Figure 1)
Chipper Funnel
Chipper engine and box assembly (pre-assembled)
Chipper Chute
Hardware Bag
Trailer hitch and funnel handles packaged together
4. Disconnect The Spark Plug Wire
Before setting up your chipper shredder, disconnect the spark plug
wire from the spark plug and ground against the engine to prevent
inadvertent starting of the machine. This step should be taken as a
precaution whenever you are working on this machine.
Figure 1
5. Attaching the chipper funnel
The first step is to attach the 2 handles to the sides of the funnel using
the wrench provided and a Phillips head screw driver (Figure 3). Tighten
the nuts securely.
The second step is to place the funnel over the opening on the chipper
box, ensuring the rubber gasket is correctly aligned. Secure the funnel
using the two “swing up bolts” and the one fixed bolt using the wrench
provided. Tighten the nuts securely (Figure 4).
Figure 3
3. Verify all parts in the hardware bag (See Figure 2)
Hearing protection
Gloves
Goggles (eye protection)
Oil fill funnel
Chip collection bag
Wrench for assembly of the chute and funnel
Hardware bag with a spare blade
Figure 2
Figure 4
5. Attaching the Side Chipper Chute
Place the chipper chute over the
four bolts protruding from the
side of the chipper box and
secure the nuts tightly using the
wrench provided (Figure 5).
Figure 5
6. Attaching the chip collection bag
Place the metal grommets of the bag over the wire loops located at the
base of the engine. Wrap the bag under the bottom of the discharge
chute and pull the draw string tightly and secure it.
7. Attaching the trailer hitch
Place the trailer hitch into the socket at the base of the chipper over the
axle assembly. Insert the pin and secure with the
locking cotter pin.
8. Re-connect the spark plug wire
