8.6 Knee Friction Adjustment
Turn screw with 3mm hex wrench:
Clockwise to increase resistance.
Anti Clockwise to decrease resistance.
With the lock lever in the “Unlock” position, turn set
screw with 2.5mm wrench to disable the lock
function. Be sure to tighten the screws on both sides
so that the lock lever does not spring back to lock
position. The knee will then function as an unlocked
5-bar knee.
IMPORTANT!: DO NOT ADJUST HEAD TILT
FEATURE IF KNEE WILL BE USED WITH MANUAL
LOCK FEATURE! FEATURE MAY INTERFERE
WITH LOCK ENGAGEMENT!
8.4 Lock Disable Mechanism
8.3 Pyramid Head Position Adjusting
Loosen set screw with
2.5mm hex wrench.
Note: Mark/indicate pyramid orientation. Remove pyramid bolt and apply thread
locker, and torque bolt 18Nm. Tighten set screw to help prevent rotation.
With 8mm hex wrench, loosen Pyramid
bolt Rotate to desired orientation and
retighten bolt.
Turn screws equally so friction
is distributed evenly on linkage
bearing.