POWAVATOR 150
6:3 SERVICE SCHEDULE
ON DELIVERY AND AFTER FIRST 8 HOURS
All Nuts and Bolts Check and tighten if required
EVERY 10 HOURS (DAILY)
1.
Check that all safety guards are correctly fitted
and in good condition.
2.
Replace any bent, worn or missing blades/spikes
and check that the fixings are tight.
3.
Grease the PTO drive shaft bearings.
4.
Oil the trailing board hinges.
EVERY 50 HOURS (WEEKLY)
All Nuts and Bolts Check and tighten if required
Hydraulic Hoses and Fittings
Check condition
Grease Points
Lubricate
Replace wearing parts as necessary to prevent
damage to non-wearing parts.
1.
Check the gearbox oil level.
Change oil after first 10 hours then every 500
hours.
2.
Check side drive oil level.
Change oil after first 10 hours then every 500
hours.
3.
Grease rotor stub axle bearing, PTO drive shaft
telescopic sections.
4.
Oil the depth control pivot points.
EVERY 500 HOURS (THREE MONTHLY)
1.
Drain, flush and refill the gearbox and side drive
with oil.
This operation is best carried out after the
machine has been run for a few minutes so that
any sediment is held in suspension in the oil.
2.
Check the condition of the side drive and rotor
stub axle wear skids and replace if necessary.
Summary of Contents for POWAVATOR 150
