4
II.
ANTENNA ASSEMBLY
2.1
Assembling the Reflector/AZ/EL Skew Cap Mount (Ref. Fig. 2.1)
Place the reflector/AZ/EL Skew Cap Mount assembly (A/B) onto mast pipe as shown in Figure 2.1.
2.2
Attach the Feed Support Arm Assembly to the Reflector (Ref. Fig. 2.1)
R e m ove the nut and flat washer from the M8 x 60mm hex head bolt from the feed support (C) and insert the fe e d
s u p p o rt into the socke t on the bottom of the reflector (B). Secure the feed support with the flat washer and M8 hex
nut. While holding the M8 x 60mm bolt head with a wrench, tighten and torque hex nut to 6 Ft-lbs.
FIG. 2.1
A. AZ/EL Skew Mount Cap
B. 75 cm Elliptical Reflector
C. Feed Support Arm Assembly
D. Transmitter
E. Feed Assembly
Summary of Contents for 75cm ELLIPTICAL Rx-Tx ANTENNA SYSTEM
Page 11: ...10 ...