Page 3
1
GX2000/GX2100
10.13.3 Priority Scanning
(
P-SCAN
)
In the default setting, Channel 16 is set as the priority channel. You may change
the priority channel to the desired channel from the Channel 16 by the Radio
Setup Mode, refer to section “
12.7 PRIORITY CHANNEL SET
.”
1. Adjust the
SQL
knob until background noise disappears.
2. Select a desired channel to be scanned using the
CH
knob.
3. Press the one of the Programmable key momen-
tarily to indicate these function on the LCD, then
press and hold the [
SCAN
] key for one second,
“
MEM
” will appear on the display which indicates
the channel has been programmed into the transceivers memory.
4. Repeat steps 2 and 3 for all the desired channels to be scanned.
5. To DELETE a channel from the transceiver’s memory, select the channel
then press and hold the [
SCAN
] key until “
MEM
” disappears from the LCD.
6. To start priority scanning, press the [
SCAN
] key
momentarily. “
P-SCAN
P-SCAN
P-SCAN
P-SCAN
P-SCAN
” appears on the LCD. Scan-
ning will proceed between the memorized channels
and the priority channel. The priority channel will be
scanned after each programmed channel.
7. To stop scanning, press the [
16/9
] or [
WX
] key.
You may change the scan resume time in the Radio Setup Mode, refer to
section “
12.9 SCAN RESUME TIME
.”
