HX290
Page 24
6.9.2 PROGRAMMING SCAN MEMORY
1. Turn the transceiver off by rotating the
VOL
knob fully
counter-clockwise.
2. Hold down the
key, and then turn on the transceiver
while still holding down the
key.
3. “
SEt
” will appear on the display, indicating the Menu
(“Set”) Mode has been activated.
4. Press the
key, repeatedly if necessary to select the
Menu item “
SCn
”.
5. Press the
or
key to select desired channel to be
scanned, then press the
key. The “
SCN
” icon ap-
pears on the display, which indicates the channel has
been selected to the scan channel.
6. Repeat step 5 for all the desired channels to be pro-
grammed into scan memory.
7. To DELETE a channel from the list, select the channel
then press the
key. The “
SCN
” icon disappears from
the display.
8. When you have completed programming the scan memory, turn the trans-
ceiver off and on by rotating the
VOL
knob.
6.9.3 MEMORY SCANNING
(
M-SCAN
)
1. Adjust the SQL level until background noise is eliminated by pressing the
key followed by the
or
key.
2. Press the
key to start scanning channels pro-
grammed into scan memory and preset channels.
The “
SCN
” icon will appear at the left of the channel num-
ber on the display during scanning.
3. When the
HX290
receives a transmission, it will stop on the channel until
signal disappears, then start scanning again.
4. To stop the scan, press the
key briefly.
6.9.4 PRIORITY SCANNING
(
P-SCAN
)
1. Adjust the SQL level until background noise is eliminated by pressing the
key followed by the
or
key.
2. To start scanning, press the
key. The scan proceeds from the lowest to
the highest programmed channel and the Priority Chan-
nel (Channel 16). The “
PRI
” and “
SCN
” icons will appear
at the left of the channel number on the display during
scanning.
3. When the
HX290
receives a transmission on a working channel, it will stop
