HX280E
Page 8
4.2.2 BATTERY INSTALLATION/REMOVAL
To install the battery pack, hold the transceiver with your left hand, so your
palm is over the speaker and your thumb is on the top of the belt clip. Insert
the battery pack into the bat-
tery compartment on the back
of the radio while tilting the Belt
Clip outward, then push the
bottom side of the battery pack
until the battery pack locks with
the Battery Pack Latch.
To remove the battery, turn the radio off. Slide the Battery Pack Latch on
the bottom of the radio, then slide the battery downward and out from the
radio while holding the Belt Clip.
4.2.3 BATTERY CHARGING
1. Turn the transceiver off.
2.
PA-48C/U
: Insert the DC plug from the
PA-48C/U
into the DC jack on the
CD-46
side panel, then plug the
PA-48C/U
into
the AC line outlet.
E-DC-19A
: Insert the DC plug from the
E-DC-19A
into the DC jack on the
CD-46
side panel, then insert the 12 V DC con-
nector into a suitable DC supply (10 - 14
VDC).
3. Insert the
HX280E
(with the battery pack)
into the
CD-46
; the antenna should be at
the left side when viewing the charger
from the front.
4. If the
HX280E
is inserted correctly, the Red “
CHARGING
” indicator will
glow. A fully-discharged pack will be charged completely in approximately
6 hours.
5. When charging is completed, the red LED indicator will change to green.
Remove the transceiver from the
CD-46
, and unplug the
NC-90C/U
from
the AC line outlet (
PA-48C/U
) or unplug the
E-DC-19A
from the DC supply
(
E-DC-19A
).
CAUTION
The
CD-46
is NOT designed to be waterproof. Do not attempt to charge
in water hazardous locations.
Tilt the Belt Clip
Insert the Battery Pack
Push the bottom side of
the battery pack
PA-48C/U
CD-46
