Standard Horizon GX2400GPS, Owner'S Manual

Page: 117 / 148

115
19 GPS SETUP
The “GPS Setup” mode allows the parameters for the NMEA2000 or the NMEA
-0183 or the Internal GPS receiver to be customized for your operating requirements.
19.1 ORDER OF PRIORITY
Specify the order of priority of the input devices to be used for obtaining loca -
tion information. The default setting is “NMEA2000”.
1.
Press & hold [
]

“
GPS SETUP
”

“
ORDER OF PRIORITY
”
2. Rotate the DIAL/ENT knob to select “ NMEA2000 ” or
“ NMEA-0183 ”, then press the [ ENTER ] soft key to
save the new setting.
3. Press the [ CLEAR ] key to return to radio operation.
NOTE
The Internal GPS receiver is always set as the lowest priority.
19.2 COMPASS DIRECTION
This menu item selects the compass direction to be shown on the transceiver
display. The default setting is “COURSE-UP”.
1.
Press & hold [
]

“ GPS SETUP ”

“ COMPASS DIRECTION ”
2. Rotate the
DIAL/ENT
knob to select the desired
compass display to “ COURSE-UP ” or “ NORTH-UP ”.
3. Press the [ ENTER ] soft key to save the new setting.
4. Press the [ CLEAR ] key to return to radio operation.
19.3 LOCATION FORMAT
This menu item selects the coordinate system to be shown on the transceiver
display. The default setting is “ddd°mm.mmmm”.
1.
Press & hold [
]

“ GPS SETUP ”

“ LOCATION FORMAT ”
2. Rotate the DIAL/ENT knob to select the desired coor -
dinate system. The location format can be selected
from “ ddd°mm.mmmm ” and “ ddd°mm’ss” ”.
3. Press the [ ENTER ] soft key to save the new setting.
4. Press the [ CLEAR ] key to return to radio operation.