The following explains how to use the features added in software version 4.
New Key Functions
A key PRESS is a normal short key activation, a key HOLD is a continuous key
activation for 1 second. When a key is pressed there is a short beep. After it has
been held for 1 second there is a long beep. Hold the Lamp or Alarm key when
changing values for faster increase or decrease of value. (eg alarm depths)
Gain Menu Removed
There is no longer a separate gain menu. This has been replaced by the new
gain feature.
New Gain Feature
The cursor key alters gain except when a menu is displayed. The gain setting is
displayed at the top of the screen. To set gain use the Cursor key which in-
creases or decreases the manual value through levels M1 to M8 then cycles to
auto gain. (Auto is displayed A1 to A7)
New Page Back Feature
Hold the Page key to jump to the page you last altered. When a page is displayed
holding the Page key steps backwards through the menus.
New Depth Range Quick Set
Depth Range can now be quickly set to display the bottom at the best available
range setting. Hold the Cursor key (either way) for 1 second or longer.
New Jump to NAV Screen Feature
By holding the Power key while in the Fish mode you jump to the NAV screen
retaining the Autofish or Echo modes. (Note that the power off sequence is started
then aborted.) Press Power key to return to fish mode.
New Individual Alarm Off Feature
While setting either the Shallow or Deep alarm depths, pressing both the Alarm and
Lamp keys simultaneously will switch the alarm off without changing the depth.
How to Calibrate Speed: Log Method (Strike 220s only)
Go to the SETUP 2 Menu / RESET LOG and reset the log to zero. Travel a
known distance of at least a nautical mile between two points in a straight line.
Best results are achieved in calm conditions where there is minimal current (best
at high or low tide).
Divide the known distance by the distance indicated on the log to get the correc-
tion factor.
Multiply your displayed speed by the correction factor to get actual speed, and
go to SETUP 2 Menu / SPD CAL to adjust to that speed. (Tip: Use simulate
mode to do this while stationary).
For example, if you have travelled a known distance of 2.0 miles but your log is reading
1.6, then the correction factor is 1.25. (ie Correction Factor = 2.0 ÷ 1.6 = 1.25)
(Note: If there is a current, travel the distance in both directions to negate the
effects of the current. It is essential to travel as near to parallel to the current as
you can. If you cannot do this then the error caused by the cross current is
reduced when the boatspeed is greater than ten times the current.)
Note: If you have another calibrated device, or can match the speed of another
boat then you may recalibrate speed under SETUP 2 / SPD CAL. Increase or
decrease as required.
Strike 220s NAV screen shows
“A7” (Auto Gain at level 7)
Strike 200 NAV screen shows “M4”
(Manual Gain at level 4)
Addendum to Horizon Strike 200/220s Owner’s Manual
1950854A
LA000052
Power key
Lamp key
Alarm key
Cursor key for
upgraded
hardware
Names of Keys.
Cursor key for
earlier models
Insert
Strike 200/220s
Owner’s Manual Insert
Page 1 0f 1
Page key
page
