P.O. Box 2684
03001 Vilnius, Lithuania
Phone: +370-5-2651474
Fax: +370-5-2651483
E-mail: [email protected]
Manufacturer of Opto-Mechanical equipment for research, industry and education
http://www.standa.lt
7
2.1.3 Connection and installation of pneumatic vibration isolation components
Insert the pipes, through the hole for air
supply pipe, into the collet fittings until tight. Pull
the pipes accurately to make sure that the
connection is secure.
The length of the pipes between the fittings
must be optimal with a small extra length.
Warning
Cut the edges of the pipes using a sharp
cutter at a straight angle. It is not advisable
to use scissors because deformation of the
pipe edges may lead to leaks from the
system.
Attach the pneumo isolation element to the
leg assembly by M6x10 screws through the
clamps.
Fig. 5. Connection and installation of pneumatic vibration isolation components