ASSEMBLY INSTRUCTIONS
9
STEP 4:
There is an
“R”
decal on the
RIGHT FRONT SWING ARM(6),
and an
“L”
decal on the
LEFT FRONT SWING ARM(4).
Hook the
LEFT
FRONT SWING ARM(4)
and
LEFT REAR SWING ARM(5)
onto the
PIVOTING JOINTS(16)
on the left side of the
UPRIGHT(1).
STEP 6
Secure the
LEFT FRONT SWING ARM(4)
to the
PIVOTING JOINT
(16)
with the
SUPPORT BRACKET(11),
two
BUTTON HEAD BOLTS
(M8x1.25x40mm)(35),
and two
NYLOCK NUTS(M8x1.25)(43).
Repeat the above assembly steps for the right side.
STEP 5
Secure the
LEFT REAR SWING ARM(5)
to the
PIVOTING JOINT(16)
with the
SUPPORT BRACKET(11),
two
BUTTON
HEAD BOLTS(M8x1.25x40mm)(35),
and
two
NYLOCK NUTS(M8x1.25)(43).
L
R
Swing Arm
Assembly
Protection Cap
Protection Caps
A.
NOTE:
Refer to illustration A. The Protection Caps are used only for
protection during shipment. Remove and discard the Protection
Caps which are covered in the ends of the Swing Arm Assembly.
NOTE:
Check the
PIVOTING JOINTS(16)
area. If there is any excess
grease, please wipe it off with an absorbent cloth.
Summary of Contents for SlimStriderX 55-9163
Page 1: ...CAUTION Weight on this product should not exceed 300 lbs...
Page 18: ...PRODUCT PARTS DRAWING 18 FRONT BACK...
Page 22: ...NOTES 22...
Page 24: ......
