Stamina 40-0041A, Owner'S Manual

Page: 9 / 18

COUNT :
SCAN:
REPS/MIN:
TIME:
CALORIE:
Upper readout displays the total number of strides you have taken from zero to 9999 strides.
Automatically scans each function of REPS/MIN, TIME, and CALORIE in sequence with
change every six seconds. Press and release the button until the arrow appears on the
display and points to the SCAN.
Displays the rate of strides per minute.
Displays the stepping time from one second up to 99:59 minutes. After six seconds of inactivity,
the meter will automatically stop timing the workout. Restart the workout time by moving the
pedals.
Displays the calorie burned from zero to 9999 Kcal.
The calorie readout is an estimate for an average user. It should be used only as a comparison
between workouts on this unit.
OPERATIONAL INSTRUCTIONS
9
USING THE FITNESS MONITOR
POWER OFF:
After four minutes of inactivity, the monitor
automatically shuts off. Function values are not
saved.
POWER ON:
FUNCTIONS:
FUNCTION BUTTON:
Press and release to select the function of the lower readout.
Press and hold for three seconds to reset all functions to zero.
Pedal movement or press the button.
BATTERY
The monitor operates with a 1.5v LR44 button cell battery. Replace the battery when you see inconsistencies
in the display.
CALORIE
COUNT
TIME
SCAN
REPS
MIN
MODE
HOW TO INSTALL AND REPLACE BATTERY:
1. Remove the MONITOR(7) from the Stamina® Mini Stepper. Unplug
the SENSOR WIRE(24) . Place the MONITOR(7) up-side down as
shown in the illustration.
2. Refer to the illustration. Slide out the old battery.
3. Install a new button cell battery. Assembly the MONITOR(7) back to
the Stamina® Mini Stepper.
LR44
Battery
1. Ultimate disposal of battery should be handled according
to all state and federal laws and regulations.
2. Do not dispose of batteries in fire.
NOTE: