Stamina 35-1050, Owner'S Manual

Page: 12 / 22

The safety and integrity designed into the
BODYTRAC TM
can only be maintained when the
BODYTRAC TM
is regularly examined for damage and wear. Special attention should be given to the following:
MAINTENANCE
1.
2.
3.
4.
5.
6.
7.
Pull on the
HANDLEBARS(17, 18)
and verify that the
SHOCK(22)
provides tension. The
SHOCK(22)
should provide many years of use.
Clean the roller tracks in the
CENTER BEAM(1)
with an absorbent cloth.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten
loose nuts and bolts.
Worn or damaged components shall be replaced immediately or the
BODYTRAC TM removed from service
until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the
BODYTRAC
TM
.
Keep your BODYTRAC TM clean by wiping with an absorbent cloth after use.
ADJUSTING RESISTANCE
The resistance of the shocks can be adjusted by twisting the adjustment
knob at the top of the shocks. There are settings from 1 to 12. Setting #1
will provide the lowest resistance. Setting #12 will provide the highest
resistance.
CAUTION:
The shocks get
HOT
after a few minutes of use.
Adjustment
Knob
Mark
12