ASSEMBLY INSTRUCTIONS
STEP 5
NOTE:
There is a red strap and a black strap attached inside of the
UPRIGHT(5).
These straps are to
assist in pulling the
SENSOR WIRE(34)
and
TENSION CABLE(23)
through the
UPRIGHT(5).
Red Strap
Black Strap
9
Tie the red strap to the plug end of the
SENSOR WIRE(34).
And tie the black strap to the cable end of
the
TENSION CABLE(23).
Pull the straps from their top ends
to pull the
SENSOR WIRE(34)
through to
extend out of the top of the
UPRIGHT(5),
and pull the
TENSION CABLE(23)
through and extend out from
the square hole at the side of the
UPRIGHT(5)
as shown in the below illustration.
Insert the
UPRIGHT(5)
into the
MAIN FRAME(1)
and tighten securely with
BUTTON HEAD BOLTS
(M8x1.25x15mm)(46), LOCK WASHERS(M8)(52), ARC WASHERS(M8)(53),
and
WASHERS(M8)(54).
NOTE:
Don’t remove the straps from the
SENSOR WIRE(34)
and
TENSION CABLE(23)
until instructed
to do so in later assembly steps.
