PL
EN
31
Operation as a Screwdriver
• Select the desired speed/torque range using the 3 speed gear shift lever (5) on the top
of tool to match the speed and torque to the planned operation.
• Insert the desire fastener accessory into the chuck as you would any drill bit.
• Select forward or reverse rotation using the slider(2).
• Set the torque adjustment collar(g. D). Set It to position 1 and begin screw driving at
low torque. If the clutch ratchets too soon, adjust the collar to increase the torque as
require
• Make a few practice runs in scrap or unseen areas to de- temine the proper position of
the torque adjustment collar.
Maintenance
Your ASAKI Power Tool has been designed to operate over a long period of time with a
minimum of maintenance. Conti- nuous satisfactory operation depends upon proper
tool care and regular cleaning.
With the motor running, blow dirt and dust out of all air vents with dry air at least once
a weak. Wear safety glasses
when performing this. Exterior plastic parts may be cleaned d.
with a damp cloth and mild detergent. Although these parts are highly solvent resistant.
NEVER use solvents.
WARNING:
Disconnect the charger from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the charger using a cloth or soft non-
metallic brush. Do not use water or any cleaning solution.
IMPORTANT:
To assure product SAFETY and RELIABILTY, repairs, maintenance and
adjustment should be performed by authorize service centers or other qualied service
organizations. Always using identical replacements parts.
Accessories
The perfomance of any power tool is dependent upon the accessory used. ASAKI
accessories are engineered to high quality standards and are designed to enhance
the perform- ance of power tool. Buying a ASAKI accessory will ensure
that you get the very best from your ASAKI tool. recommended accessories for use with
you tool are available for purchase from your local dealer.
ACAUTION:
The use of any non-recommended accessory may be hazardous.
Maximum Recommended capacities
Speed 1
Speed 2
BITS.METAL DRILLING
10 mm (1/2") 6,4 mm (1/4)
WOOD. FIAT BORING 25 mm (1–1/2") 16 mm (5/8")
TOOL CLEANING INSTRUCTIONS:
CHARGER CLEANING INSTRUCTIONS:
ORIGINAL INSTR
UCTION