Stairville MaTrixx TLB-20 MK-II RGBW, User Manual

Page: 27 / 44

This setting is only relevant if the unit is controlled via DMX.
Press
[Mode] repeatedly until the display shows ‘dxxx’ .
Now you can set the number of the first DMX channel to be used by the device (DMX address).
Use [UP] and [Down] to select a value between 1 and 512 (the display shows ‘d001’ … ‘d512’ ).
Make sure that this number matches the configuration of your DMX controller. The following
table shows the highest possible DMX address for the different DMX modes.
Mode Highest possible DMX address
2-channel 511
3-channel 510
Press [Setup] . Use [UP] and [Down] to select one of the following DMX operating modes:
n
‘d-P1’ (three channels)
n ‘d-P2’ (two channels)
Wait about 30 seconds until the display turns off. Then the settings have been applied. To
return to the higher menu level without changes, press [Mode] .
DMX mode
Operation
MaTrixx TLB-20MK-II RGBW
27