CAUTION!
Risk of injury due to movements of the device
The head of the device can move quickly (pan, tilt) and can produce
very bright light. This is also valid immediately after you turn on the
device, when the device operates in automatic mode or under remote
control and when you turn off a DMX controller that is connected to the
device. Persons staying near the device could be injured or frightened.
Before you turn on the device and during the operation, always ensure
that nobody stays close to the device. If work has to be performed in the
area of movement or in the near vicinity of the device, it must remain
turned off.
5.
Confirm your selection with
[ENTER]
ð
The device immediately performs an automatic selftest. The following
functions are tested: Pan, tilt, shutter, colour, gobos, gobo rotation, prism,
prism rotation, frost, zoom, focus and dimmer.
6.
To exit the automatic selftest, press
[MENU]
.
1.
To enter the main menu, press
[MENU]
.
2.
Use
[UP]
and
[DOWN]
to navigate to menu item
‘Fixture Test’
.
3.
To open the
‘Fixture Test’
menu, press
[ENTER]
.
4.
Use
[UP]
and
[DOWN]
to select the submenu
‘Manual Test’
.
CAUTION!
Risk of injury due to movements of the device
The head of the device can move quickly (pan, tilt) and can produce
very bright light. This is also valid immediately after you turn on the
device, when the device operates in automatic mode or under remote
control and when you turn off a DMX controller that is connected to the
device. Persons staying near the device could be injured or frightened.
Before you turn on the device and during the operation, always ensure
that nobody stays close to the device. If work has to be performed in the
area of movement or in the near vicinity of the device, it must remain
turned off.
5.
Confirm your selection with
[ENTER]
.
ð
A sub-menu opens up in which the following functions can be tested man-
ually: Pan, tilt, shutter, colour, gobos, gobo rotation, prism, prism rotation,
frost, zoom, focus and dimmer.
6.
Use
[UP]
and
[DOWN]
to navigate to the desired menu item.
7.
Use
[UP]
and
[DOWN]
to change the respective value.
ð
The results of your settings are immediately effective.
Performing manual selftest
Operating
BSW-100 LED BeamSpotWash
21