Included Parts:
1. Controller
2. Triac
3. Temperature Strips
Required Tools:
1. #1 Phillips Screwdriver
2. #2 Phillips Screwdriver
3. Short #2 Phillips Screwdriver or
Ratchet w/ #2 Phillips bit
4. Scissors
5. Paper Clip
1. Required Tools: Paper Clip
2. CAUTION: Turn off power and detach power cord
3. Insert the Paper Clip into the small hole on either
side of the housing
4. Press in the Paper Clip until two clicks are heard:
the first click releases the Controller bezel and the
second click ejects it from the housing as shown
5. Repeat the process on the other side of housing
6. Remove the old Controller and insert the new
replacement Controller
7. Press on the two latch points with your thumb until
a click is heard; if the Controller bezel does not sit
flush with the housing plastic, it has not latched
8. Plug in and turn on heat press to verify function
Controller Replacement Guide
Fusion IQ ( XF/XRF/XRF2)
Page 1 of 1
2018-04-26
1-800-727-8520
www.hotronix.com
Dual Air Fusion [Model XRF2-IQ]
Controller and Triac
Fusion (Model XF)
Controller V4.5 & TRIAC Replacement
2015-03-08
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals
Page 1 of 17
Included Parts:
1. Controller
2. Controller Overlay
3. Temperature strips
4. Zip ties
5. TRIAC
6. Adapter Harness (older models only)
7. 9-Pin Connector (where applicable)
Required Tools:
8.
Allen Wrenches (3/32” & 9/64”)
9. #2 Phillips Screwdriver
10. #1 Phillips Screwdriver
11. 2mm Precision Flathead Screwdriver
12. Scissors
13. Wire Cutters (9-pin repair only)
14. Wire Strippers (9-pin repair only)
15. Permanent Marker (9-pin repair only)
CAUTION: Detach power cord before
proceeding
1
2
3
4
5
6
7
8
9
10
11
12
13
14 15
Page 1 of 16
44
4.5
Press Mount Casting Replacement
XRF2 Dual Air Fusion
2016-12-28
Page 2 of 23
Remove Press Mount Cover
by unscrewing 4x #8-32 x
1/4” Screws using #2 Phillips
Screwdriver
Turn press ON and set timer for 15
seconds or more
Press Print Switches to lower
heater
