Stahl SolConeX 7570/11 Series, Operating Instructions Manual

Page: 31 / 37

126407 / 7570601300
2014-01-21·BA00·III·en·01
Commissioning
13
SolConeX Wall-Mounted Socket, 16 A
Series 7570/11
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
8 Commissioning
Before commissioning, ensure the following:
• Check mounting and installation.
• Inspect enclosure for damage.
• If necessary, remove foreign objects.
• If necessary, clean the connection chamber.
• Check whether the cables have been inserted correctly.
• Check whether all screws and nuts have been tightened firmly.
• Check whether all the cable glands and stopping plugs have been tightened firmly.
• Check whether all conductors have been clamped firmly.
• Observe the line voltage.
• Seal unused cable entries with plugs certified according to directive 94/9/EC and
unused drilled bores with stopping plugs certified to directive 94/9/EC.
• Use only in completely mounted state.
9 Operation
Only type 7570/12 and 8570/12 plugs by R. STAHL may be used.
WARNING
Check the device before commissioning!
Explosion protection is impaired!
• Observe the inspection requirements in the current national
regulations before commissioning in order to maintain the
explosion protection.
• Check the device for proper installation and function before
commissioning.
Switching on and off has to be performed quickly and completely.
Avoid switching positions between 0 and I (ON and OFF).
The wall-mounting socket may only be operated when fully mounted.
The wall-mounting socket can be switched only with the plug inserted.
When the plug has been disconnected, close the hinged cover with the
bayonet ring.