250318 / MCP60300110
2021-01-26·BA00·III·en·02
Mounting and Installation
15
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Flameproof Manual Call Points
Series MCP/BG
7.3.6 Standard Devices with LED Status Light
Single-pole MCP, switch normally closed in standby / normally open in alarm
• Ensure that the connector wires from switch and LED are correctly installed as per the
schematic (see the following figure).
• Remove LK1 for LED activation in alarm or remove LK2 for LED activation in standby.
• Add a jumper/connection between terminals 1 and 2. Terminal 1 is the one closest to
LK3. The jumper/connection is depicted in the figure.
There is an 820 ohm resistor which is in line with the LED. When activated,
the LED together with the resistor will draw a current. On a 24 V DC system
this current is approximately 30 mA.
17567E00
17655E00
C
1
1a
2
3
4
Connector terminal
Red wire for LED
Black wire for LED
Blue wire for switch
Yellow wire for switch
Red wire for switch
17654E00
1
2
3
Cable connection (from left)
L / +
N / -
1a
2a
3a
4a
1
2
3
4
C
LK2
LK1
LK3
N/O
N/C
Common
1
2
3
