Safety Notes
6
125711 / 704060300010
2019-02-19·BA00·III·en·04
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Control Unit System
Series ConSig 7040
3.3
Safe Use
Before mounting
• Read and observe the safety notes in these operating instructions!
• Ensure that the contents of these operating instructions are fully understood by the
personnel in charge.
• Use the device in accordance with its intended and approved purpose only.
• Always consult with R. STAHL Schaltgeräte GmbH if using the device under operating
conditions which are not covered by the technical data.
• Before installation, make sure that the device is not damaged.
• We cannot be held liable for damage at the device caused by incorrect or unauthorised
use or non-compliance with these operating instructions.
For mounting and installation
• Have mounting and installation performed only by qualified and authorised persons
(see chapter "Qualification of the personnel").
• The device is only to be installed in areas for which it is suited based on its marking.
• During installation and operation, observe the information (characteristic values and
rated operating conditions) on the rating, data and information plates located on the
device.
• Before installation, make sure that the device is not damaged.
• Only use installation components (e.g. cable entries) that have an
"EC Type Examination Certificate" or an "ATEX Certificate of Conformity".
• Observe the installation conditions of potential installation components
(See the "Technical data" section).
• Ensure that cable entries from manufacturers other than R. STAHL have a correct and
sufficient degree of protection.
• Do not subject cable entries and stopping plugs to any tensile stress and tighten them
with the right torque (for information on torque, see the operating instructions for the
cable gland).
Commissioning, maintenance, repair
• Only have commissioning and repairs performed by qualified and authorised persons
(see chapter "Personnel qualification").
• Before commissioning, make sure that the device is not damaged.
• Perform only maintenance work described in these operating instructions.
• The device must be operated if there are dust deposits that are ≥ 50 mm,
as stated in IEC/EN 60079-31.
Summary of Contents for ConSig 7040 Series
Page 20: ......
