133285 / 8118609300
2019-11-13·BA00·III·de·06
Produktauswahl, Projektierung und Modifikation
9
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
Klemmenkästen
Reihe 8118/1, Reihe 8118/2
5.1
Zusätzliche Bohrungen
5.1.1 Zusätzliche Bohrungen durch R. STAHL anbringen
An R. STAHL folgende Informationen übermitteln:
- Typ
- Datenblatt
- Anzahl, Hersteller und Zulassungen der einzubauenden Komponenten.
R. STAHL
• überprüft, ob die Komponenten, Bohrungsdurchmesser, Anzahl und Position der
Zulassung entsprechen
• bringt die Bohrungen an
• montiert die Komponenten
• führt die Auftragsdokumentation nach
• führt eine Stückprüfung durch
• bringt, falls erforderlich, ein neues Typschild an, sofern sich die technischen Daten,
wie z.B. durch die zusätzlich einzubauenden Komponenten, geändert haben.
5.1.2 Zusätzliche Bohrungen durch den Kunden anbringen
5.1.2.1 Gehäuse
Nutzbare Fläche für Leitungseinführungen im Gehäuse berechnen
Die Berechnung wird in drei Schritten durchgeführt:
Gesamte, nutzbare Fläche berechnen
Benötigte Fläche für Leitungseinführungen berechnen
Verbleibende nutzbare Fläche berechnen.
1.) Gesamte nutzbare Fläche berechnen
Die gesamte, nutzbare Fläche für den Einbau errechnet sich wie folgt:
(Gehäuseinnenwand-Länge ‒ 2 x 10 mm
*
) x (Gehäuseinnenwand-Höhe ‒ 2 x 10 mm
*
)
*2 x 10 mm = umlaufender Rand an der Gehäuseinnenwand
Wichtig für die folgende Berechnung:
Maße an der Planfläche der Gehäuse-Innenseite messen
(nicht an der Gehäuse-Außenseite)
Zusätzlichen Platzbedarf für Blindnietmuttern berücksichtigen. Der Platzbedarf des
Einbauteiles ergibt sich aus dem Eckenmaß der Leitungseinführung und dem
Zuschlag für das Werkzeug.
Summary of Contents for 8118/1 Series
Page 49: ......