User’s manUal
mPas 80/10 & mPas 80/12
How to operate the Mpas 80/10 or Mpas 80/12
1 - LINK OUTpUT
- This 1/4’’ jack socket features a line level output w/ 1k Ohm impedance@-10dBV.
It is used to connect the MPAS 80/10 or 12 to an additional power amplifier, to another powered speaker
or to a recording system.
This line level signal source is the same as the one at input
3
.
2 - mIC Input
- This low impedance (1 k Ohm, typical) XLR input socket is designed to connect low
impedance microphones with balanced output. Wiring of the 3-pin connector is: Pin 1= Shield; Pin 2 =
Positive (Hot); Pin 3 + Negative ( Cold).
3 - LINE Input
- This 1/4” input jack features a high impedance (100k Ohm, typical) to connect high
impedance microphones or devices with a line level output, such as: Tape/CD/Radio players/Effect gears
(Return Loop), etc. An Electric/Bass guitar or a keyboard can also be plugged in.
Both the high and the low impedance inputs may be used simultaneously.
4 - mIC/LINE Volume
- Controls the overall listening volume of the MIC/LINE mix.
5 - HIGH
- Adjusts the high-end frequency level of the EQ in the tone section.
6 - mIDDLE
- Adjusts the mid-end frequency level of the EQ in the tone section.
7 - LOW
- Adjusts the low-end frequency level of the EQ in the tone section.
8 - aUXILaRY
Volume - This Control adjusts the level of the playback inputs: RCA/Phono/Cinch sockets
on the control panel, see
9
9 - aUXILaRY IN
- These RCA/Phono (RCA/Cinch) sockets are provided for connecting external sound
sources such as: CD/MD/Tape machines. Left and Right inputs are linked together for monophonic use.
10 - pOsT EQ
- Both RCA/Phono (RCA/Cinch) sockets deliver a line-level, post EQ, output signal for
recording use. The output level depends on tone section.
11 - pRE EQ
- This 1/4’’ jack socket is an external output for use with an extra EQ, an active Sub
Woofer, etc. It provides a combination of all input signals and controls but is not influenced by the tone
section. The impedance is 2k Ohm.
12 - EXT. spEaKER
- This 1/4’’ jack socket is an external, 8 Ohm impedance output for use with
passive enclosures only (Extension Speaker Cabinets, Sub Woofers, etc...) featuring a minimum load
impedance of 8 Ohm.
This output provides a combination of all input signals and controls and is influenced by the tone
section.
13 - pOWER
- This ON/OFF switch activates/deactivates the unit. Red LED «ON» means
the equipment is ready to work.
When the mains switch is in position «1», the power is switched «ON».
When the mains switch is in position «0», the power is switched «OFF».
14 - maINs sOCKET
- Plug mains cable into this socket prior to connect it to the proper
power outlet. This socket also features the (T1A) Mains Fuse.
Features and Specifications are subject to change without notice