Connect the LED Strip male connector into the RGB Control box as shown in the
picture below. From there your then connect the Power supply to the RGB Control
box as the picture also shows below. The other cable on the Control Box is the IR
sensor for the Remote.
If you would like to shorten the LED strip simply cut across the copper contacts
with scissors as shown below.
NOTE: that you do not cut the wrong end of the LED Strip.
ASSEMBLY INSTRUCTIONS
1
. Cut along black line
marked with scissor
icon
5
. Snap close cover
to secure
2
. Use extension to
connect
3
. Remove silicone to
expose copper
contacts
4
. Slide the copper
contacts under the
metal contacts on the
extension for
connection
6
. The alternative to
cutting is to use the
adapter joiner at ends of
LED strip to join strips
together. Arrows on
joiners show orientation
