To stick the LED strip onto a surface, simply peel off the paper sticky underside as
shown below. Before installation of the LED strip please ensure that you wipe the
surface with an Alcohol prep pad (not supplied) to make sure it is free of dust and
grease. Press and hold the LED in position for at least 60 seconds for maximum
adhesion.
NOTE: Although LED Light Strips can be installed in curved and irregular
spaces, avoid sharp bends or bending on the solder joints as you could
damage the light strip.
ADHERING TO A SURFACE
•
Connect the RGB IR remote control box to the LED strip wire, then plug AC/DC
Adapter to the remote control box and turn on switch at power source to activate
•
Aim and press remote control at IR control box to change functions
USING THE REMOTE
