P a g e |
22
P a g e |
Note: Chain may be greasy and dirty.
Turn power switch to “OFF” position, remove battery, allow cycle to cool before beginning
repair or maintenance:
1. Ensure the power button is “OFF”.
2. Ensure the battery is removed and cycle has had adequate time to cool. (up to 30 minutes)
3. Secure the cycle for repair or maintenance.
4. Exercise caution around exposed parts.
5. Remove right side panel.
6. Rotate rear wheel until master chain link is near motor sprocket.
7. Loosen both rear axle nuts, bolt securing brake bracket and loosen chain tensioner.
8. Push wheel forward to loosen chain.
9. Remove master chain link, then chain.
10. Install replacement chain, re-attach master link.
11. Tension chain by pulling rear wheel outward with aid of chain tensioner, aligning the tire
straight forward.
12. Tighten rear axle nuts, bolt securing brake bracket and snug chain tensioner.
13. Install right side panel.
Replace Front Tire and/or Tube:
1. Loosen front axle nuts and axle keeper tabs.
2. Remove wheel.
3. Deflate tube and remove tire from wheel.
4. Install new tire and/or tube onto sidewall.
5. Inflate to pressure recommended on sidewall.
6. Install front wheel and tighten from axle nuts, positioning axle keeper tabs into lower hole
in fork blade.
Replace Rear Tire and/or Tube:
1. Remove right side panel.
2. Snip zip-tie on hose keeper on the chain stay near side panel.
3. Remove brake caliper bracket bolt.
4. Remove disc guard.
5. Loosen rear axle nuts and remove chain tensioner assembly.
6. Push rear wheel forward and remove chain from motor sprocket.
7. Remove rear wheel.
8. Deflate tube and remove tire from wheel.
9. Install new tire and/or tube onto wheel.
10. Inflate to pressure recommended on sidewall.
11. Replace wheel assembly in dropouts and disc guard.
12. Tension chain by pulling rear wheel outward with aid of chain tensioner, aligning the tire
straight forward.
13. Tighten rear axle nuts, bolt securing brake bracket and snug chain tensioner.
14. Install right side panel.
Seat Height Adjustment:
1. Release the seat height adjustment clamp and extend the seat post until the desired seat
height is achieved, then tighten the adjustment clamp. The seat post is marked with
anindicator line. Do not extend past the indicator line.
