Chapter 4. Configuring the Display System
STACK ST8110 Display System
10
User Guide Addendum
Chapter 4. Configuring the Display System
Configuration mode
The list of configurable parameters has changed significantly from that of
the ST8100. Please note that the setting for the 30PSI/150PSI FUELP
SENSOR (2BAR/10BAR for EC) must match the sensor fitted or incorrect
readings will be shown.
Configurable Parameter
Setting Required
E.S.Cylinders
Number of cylinders in engine (for RPM)
GATE RPM
Minimum RPM for the Fuel Pressure, Oil
Temperature and Pressure, and Water
Temperature warnings to operate.
LOG RPM
RPM at which the logging option is started.
SHIFT RPM
RPM at which gear shift light is to come on
HIGH WATER
Maximum water temperature alarm
HIGH OIL T
Maximum oil temperature alarm
30PSI/150PSI FUELP SENSOR To match the sensor fitted - ST744,ST745 &
ST746 are 150psi/10Bar, ST741 & ST742 are
30psi/2Bar. After changing this setting,
always check the following LOW FUEL P
setting
LOW FUEL P
Minimum fuel pressure alarm
LOW OIL P
Minimum oil pressure alarm
LOW BATT
Minimum battery voltage alarm
BOOST BAR/PSI
BAR/PSI determines which units are displayed
and used for the over-boost test. After
changing this setting, always check the
following HIGH BOOST setting
HIGH BOOST
Maximum boost pressure alarm
LAP TIME
Lap time popup duration, or disable
Summary of Contents for ST8110
Page 1: ...542035 002 ST8110 Race Turbo Display System User s Guide Addendum...
Page 2: ......
Page 6: ......
