E440 / S440 Series
Submersible Solids and
Effluent Handling Pumps
INSTALLATION, OPERATION, & PARTS MANUAL
SAFETY INFORMATION
Carefully read and follow all safety instructions in this
manual or on pump.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for
personal injury!
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The word NOTICE indicates special instructions which are
important but not related to hazards.
1.
Read these rules and instructions carefully. Failure to
follow them could lead to serious bodily injury and/or
property damage.
2.
Check your local codes before installing. You must com-
ply with their rules.
3.
Vent sewage or septic tank according to local codes.
4.
Do not install pump in any location classified as
hazardous by the National or Canadian Electrical Code.
Risk of cord damage and electrical
shock. Can burn or kill. Do not lift pump by power
cord. See “Cord Lift Warning” on Page 2.
Hazardous voltage. Can shock, burn,
or cause death. During operation the pump is in water.
To avoid fatal shocks, proceed as follows if pump needs
servicing:
5A. Disconnect the power to the outlet box before unplug-
ging the pump.
5B. Take extreme care when changing the fuses. Do not
stand in water or put your finger in a fuse socket.
5C. Do not modify the cord and plug. When using the cord
and plug, plug into a grounded outlet only. When wiring
to a system control, connect the pump ground lead to
the system ground.
6.
Do not run the pump dry. Dry running can overheat the
pump, (causing burns to anyone handling it) and will
void the warranty.
7.
Pump normally runs hot. To avoid burns when servicing
pump, allow it to cool for 20 minutes after shut-down
before handling it.
8.
In normal service, motor should not need oiling. Motor
has been filled at the factory with a special oil.
DESCRIPTION
These submersible solid and effluent handling pumps are
designed for waste water removal and for draining ground
water from excavations. All units come with a 3-prong
grounding type power cord. Pump is permanently lubricated
and includes an automatic overload protector in the motor.
© 1999 Sta-Rite Industries, Inc.
Printed in U.S.A.
S503 (8/3/99)
293 Wright Street • Delavan, WI 53115
GPM (LPM) AT TOTAL FEET (m)
5
10
15
20
25
Model
(1.5m)
(3m)
(4.6m)
(6.1m)
(7.6m)
CAPACITY GALLONS(L)/MINUTE
E440
65
57
48
38
28
37 Ft.
(246) (216)
(182)
(144)
(106) (11.3m)
S440
72
52
34
14
–
23 Ft.
(273) (197)
(129)
(53)
(–)
(7.0m)
No flow
at height
shown
below
Motor
Motor
Full Load
Cord
*Switch Setting in inches (mm)
Series
HP
Amps
Length
On
Off
E440115T
4/10
8.5
15’
15"(381)
7"(178)
E440115M
4/10
8.5
15’
–
–
S440115T
4/10
10.0
15’
15-1/2”(394)
7-1/2”(191)
PERFORMANCE
ELECTRICAL & SWITCH SPECIFICATIONS
