Connectors
STM8L1526-EVAL
24/46
Doc ID 15437 Rev 1
Note:
All I/O's marked in grey can be disconnected with function block on the STM8L1526-EVAL
board by removing LCD glass module (MB821) board.
3.5
LCD glass connector CN5 and CN6
Two 36-pin male headers, CN5 and CN6, can be used to mount the LCD glass module
(MB821) on it. Two possible mount positions may be selected by the user for either an LCD
glass demonstration or other peripherals on STM8L1526-EVAL board.
25
PF0
Motor control connector (Current B) /
BNC / Audio_DAC_out
Set JP10 to open
2
PB0
Motor control connector (Encoder A)
Disconnect power driver board from
Motor control connector
4
PB2
Motor control connector (Encoder B)
Disconnect power driver board from
Motor control connector
6
PB4
Dot-matrix LCD_CS
Remove Dot-Matrix LCD module
8
PB6
LCD_SDcard_Flash_MOSI
-
10
GND
-
-
12
PE0
CMP_Rref / Motor control connector
(NTC_bypass)
Remove R42
Disconnect power driver board from
Motor control connector
14
PE2
Joystick_sel / Motor control connector
(MC_WL)
Remove R55
Disconnect power driver board from
Motor control connector
16
PE4
Serial Flash_CS
Remove R73
18
PE6
IDD_Measurement_Wakeup
Remove LCD glass module (MB821)
0ohm resistor to be added?
20
PE7
IDD_Measurement_CNT_EN
-
22
PC3
UART_IrDA_TX
-
24
MCU_VDD
-
26
NC
-
Table 15.
Daughterboard extension connector CN10 (continued)
Pin Description
Alternative
function
How to disconnect with component
on STM8L1526-EVAL board