2
How to run the evaluation board with the preloaded firmware
To run the
evaluation board with the
preloaded firmware, you have two
possibilities to power the board up:
1.
through the micro-USB connector with an appropriated power supply (i.e. 5 V, 1 A): with this option, you
can access limited board functions like programming/debugging through the SWD connector or use the
touchscreen display to show the features of the industrial ICs mounted on the board. This mode is intended
for demonstration only or to use MCU logic circuit only;
2.
through the screw connector (24 V) placed in the bottom-left corner: this option offers the complete
experience with the
, that is all programming/debugging and display features can be
executed, and the industrial I/O can be handled with the highest possible current ratings allowed by the
ICs (i.e. you can drive several output loads requiring up to 0.7 A of current each through the output screw
connector placed on the bottom side).
provides the framework to use all the
modules including TouchGFX-based
HMI. After powering up, you just have to select one of the user modes through the touchscreen.
UM2933
How to run the evaluation board with the preloaded firmware
UM2933
-
Rev 1
page 11/42