Getting started
UM0819
9/37
Doc ID 16379 Rev 2
Figure 4.
ST802RT1 TX mode demonstration board connected to STM32F107
demonstration board
2.
Setup properly jumpers on the ST802RT1 TX mode Ethernet PHY demonstration
board. The software does not change any settings of the PHY; it reads the settings
from the PHY instead. See
Section 6.1
for more details about board setup.
3.
Connect ST802RT1 TX mode Ethernet PHY board to STM32F107 controller board.
4.
Connect Ethernet cable to the ST802RT1 TX mode Ethernet PHY board on one side
and to the PC on the other side.
5.
Flash the demonstration software into the Flash memory of the STM32F107 MCU.
6.
Configure your PC. The following description is valid for Windows
®
XP; nevertheless
it is easy to setup any other operating system in a similar way.
a)
Setup network settings: in Control Panel - Network Connections right click your
network card and open Properties.
electronic components distributor