Figure 19.
STEVAL-BLUEMIC-1 evaluation board in plastic case
2.3
STEVAL-BLUEMIC-1 evaluation board programming interface
To program the board, connect an external ST-LINK to the SWD connector on the STEVAL-BLUEMIC-1
evaluation board; a 5-pin flat cable is provided in the evaluation kit.
The easiest way to obtain an ST-LINK device is to get an STM32 Nucleo board, which bundles an ST-LINK V2.1
debugger and programmer.
1.
Ensure that CN2 jumpers are OFF and connect your STM32 Nucleo board to the STEVAL-BLUEMIC-1
evaluation board via the cable provided, paying attention to the polarity of the connectors
Pin 1 is identified by:
–
a small dot on the PCB silkscreen on the STM32 Nucleo board
–
the square shape of the soldering pad on the STEVAL-BLUEMIC-1 evaluation board
2.
Download from ST website the "BlueNRG-1 ST-LINK utility", a full-featured software interface to program the
BlueNRG-1 microcontroller.
3.
Follow the installation procedure
4.
Program the STEVAL-BLUEMIC-1 evaluation board with the demo binary available in the software package.
UM2257
STEVAL-BLUEMIC-1 evaluation board programming interface
UM2257
-
Rev 2
page 16/35
