ST ST9 EPB, User Manual, Page: 10 / 24

3 - How to Program ST9 EPB User Manual
10/24
Note:
Some ZIF sockets have levers or covers that you must lift in order to place the device, and
then re-fit after the device is in place.
7 Power on the EPB.
3.2 A typical programming session
The following instructions describe how you would typically program an ST
microcontroller using STVP9. Note that this is not the only way to program an ST
microcontroller using STVP9; for more information on how to use the STVP9, click
the Help command in the main menu bar.
1 Make sure that the microcontroller you want to program is correctly connected
for programming, either via the ZIF socket or in ISP mode (see Chapter 4: In
Situ Programming mode on page 15).
Figure 2: ZIF socket with lever
ZIF Socket
Place your device here, making sure to
1
align pin 1 on the device with the arrow
on the programming board
lever