9. Apply silicone to the top edges of the cabinet and ensure that the unfinished/raw
edge of the cabinet sides, front support rail and back are sealed before the top
is positioned. Attach the basin to the top of the cabinet with a continuous bead of
silicone and then proceed to silicone all the cabinet and shroud edges that are in
contact with the wall and floor.
A Note on Silicone:
Only use silicone especially formulated for bathroom use-
we suggest a clear silicone or a colour matched to floor to ensure the reflective
qualities of the stainless are not compromised by using a contrasting colour.
Ensure silicone is used according to manufacturers instructions.
8. When it is in place, push the back left and right ends of the shroud against the
double sided tape located on the rear legs.
The tape will help hold the shroud in place while being siliconed to the floor.
1. Ensure that the adjustable legs are pre-set at 150mm before installation begins.
Measurements are taken from the underside of the cabinet to the floor.
2. Level the cabinet by adjusting the four corner legs and ensure that the minimum
height from the underside of the cabinet to the floor is no less than 150mm.
Turn the foot clockwise to increase height.
3. Fix cabinet to the wall - Refer to General Installation Instructions.
4. When the cabinet is level unwind the middle leg clockwise until it touches the floor,
be careful not to over extend the middle leg resulting in unneccessary stressing of
the cabinet.
LEVEL CABINET
ADJUST LEG
5. Prepare double sided tape, located on the rear left and right legs, by pealing the
protective layer off and exposing the adhesive. When positioning the shroud, be
careful not to stick the shroud to the exposed adhesive before it’s fitted into its
final position.
6. Remove protective film from stainless shroud. Once the protective film has been
removed, handle with care.
7. Slide the stainless steel shroud into place. Push until the front of the shroud sits
firm against the front legs and the back of the shroud is flush with the back of the
cabinet.
EXPOSE ADHESIVE
INSTALLING SHROUD
St Michel Industries Limited, PO Box 21 122, Henderson, Auckland. Phone 09 837 4276. Fax 09 837 4325
General Installation
Information
5
STAINLESS SHROUD
INSTALLATION INSTRUCTIONS
(AS SEEN ON BLISS FURNITURE)
11/12
SILICONE FINISH
