St Michel Industries Limited, PO Box 21 122, Henderson, Auckland. Phone 09 837 4276. Fax 09 837 4325
Materials used for the construction of this unit are water
resistant and not waterproof. A bead of sealant (specifically
formulated for bathrooms)
must be used to seal all edges
where water penetration can occur. i.e. Between the
cabinet and the wall and the floor, between the vanity top
and the top edge of the cabinet and between a vessel
basin and the top surface.Take care to dry any spillage or
leakage of water onto or into the cabinet during installation.
SEALING
It is the responsibility of the installer to make any
adjustments to align doors after installation if required.
St Michel use clip hinges which require only light finger
pressure to clip into place and allow the doors to be easily
removed for access to plumbing fittings.
DOOR ALIGNMENT
Your doors have been adjusted in the factory on a level
surface to achieve matching height, equal gap and surface
alignment. Before you adjust the doors, ensure again that
the vanity is level and true and not twisted. When level, if the
doors still do not align, adjustment can be made to the
hinges as follows:
A. SIDE ADJUSTMENT
To move the doors sideays in total or to level each door, turn screw
A
clockwise or anti-clockwise.
B. DEPTH ADJUSTMENT
To move the door inward or outward from the carcass - loosen the hinge arm fastening screw
B
and slide in the direction you
want to go. Retighten hinge arm fastening screw
B
.
C. HEIGHT ADJUSTMENT
Loosen the top and bottom screw
C
on each mount plate, adjust and retighten.
HINGE ADJUSTMENT
Please note that in the event that the vanity is not installed in accordance with these instructions the St Michel warranty may
be voided. Any modifications to the product
will
void any warranty.
Please ensure that the Warranty and Conditions of Use card is left in the cabinet for the homeowner.
IMPORTANT WARRANTY NOTICE
INSTALLATION INSTRUCTIONS
In a ceramic basin,
hand tighten
the waste - do not
overtighten or the basin may be damaged. Use suitable
overflow waste and align the slots with the internal holes in
the basin and ensure that no excess silicone or putty is
obstructing the water flow.
WASTE
Align slots with
basins internal
holes.
6
7
8
IMPORTANT: PLEASE READ
PRIOR
TO INSTALLATION
FITTING WASTE CORRECTLY
General Installation
Information
5
11/12
