2
Ensure Suitability Of Location
Before making any alterations to kitchen cabinetry, you should ensure that the proposed
location for the cooktop is suitable:
Electrical supply:
there must be an earthed 240V 50 Hz 10Amp power socket within reach of the
supplied electrical cable (approximately 850mm from the rear right of the cooktop). The power
socket must be readily accessible without having to remove the appliance. If a power socket
needs to be installed or relocated, the work must be done by a licensed electrician.
Cabinetry:
We recommend that the adjacent kitchen surfaces be capable of withstanding
temperatures of 100ºC, and that the cabinetry can support the weight of the cooktop plus
fi
lled
cooking utensils. If necessary, check with the bench top supplier that the material is suitable. St
George Appliances will not be liable for heat damage to incorrectly speci
fi
ed materials.
Clearances:
Ensure there is suf
fi
cient room to install the cooktop with all required clearances as
speci
fi
ed on the next page.
Gas Supply:
Ensure that it is possible to run gas lines to the gas connection point of the
appliance. The gas connection point must be accessible without having to remove the
cooktop. If a
fl
exible hose is used, the connection point must also be accessible without having
to remove the cooktop.
Check Gas Type
Check that the gas type (ULPG or Natural Gas) available in the building matches the gas type
of the cooktop, as shown on the gas type sticker.
If the cooktop is suited to the incorrect gas type, it is possible to perform a gas conversion. This is
explained later in this manual.
Before Installation
Dimensions
4 burner models
5 burner models
A - Depth
512 mm
512 mm
B - Width
595 mm
685 mm
C - Overall Height
45 mm
45 mm
D - Height above benchtop
19 mm
19 mm
E - Gas connection point to right edge
362 mm
395 mm
F - Gas connection point to back edge
41 mm
41 mm
G - Gas connection point to top surface
of hob
62 mm
62 mm
H - electrical junction (start of 1.4 metre
power cable) to right edge
28 mm
71 mm
J - electrical junction to back edge
62 mm
62 mm
F
J
G
C
D
A
B
E
H
