IGW/100 – IGW/100 Components
S S V
E MB E DD E D
S Y ST EM S
9
If you remove the jumper cap or place the jumper cap on just one pin, the jumper
is not set and you can not use RCM.
RCM disabled (JP1 not set)
RCM enabled (JP1 set)
jumper cap
Figure 3-1: RCM-jumper in detail
If the RCM jumper is set you will see some boot messages on the serial port
COM1. If the RCM jumper is not set, these messages are blocked.
3.11 CompactFlash
Slot
With the CompactFlash slot you can use CF cards with the IGW/100.
Please see
chapter 2
how to open the IGW/100.
Note:
The CompactFlash slot works only with CF cards in True-IDE-Mode.
The CF cards must be hardwired as master.
Please see
chapter A2.4
and
A2.5
for the complete pinout of the CompactFlash
slot.
3.12
Base Address LAN 2 – JP3
The Jumper field JP3 allows you to change the base address for LAN 2. The de-
fault base address for LAN 2 is
340h
. For detailed information please refer to
chapter 4.7
.
Please see
chapter 2
how to open the IGW/100.
3.13
Base Address LAN 3 – JP4
The Jumper field JP4 allows you to change the base address for LAN 3. The de-
fault base address for LAN 3 is
360h
. Please refer to
chapter 4.7
for detailed in-
formation.
Please see
chapter 2
how to open the IGW/100.
