SSV Works GN-5K, User Manual, Page: 22 / 28

22
C
F E
A B
C. Remove push clip on the rear panel to allow the running of the
speaker harness up the driver and passenger cage bar to connect to
the speakers.
F. Using a T5 hex key tighten clamp until it secures to cage. E. Loosely install the clamp base to the cage mount pod with the two
(2) 8 mm head bolts and washers, place the cage mount pod in the
desired mounting location on the vehicle.
A. From the rear of the center console, connect the B-H1150 harness and
route to the rear driver and passenger side from under the console.
B. Make sure the speaker wire is away from any moving and sharp parts,
pull cable out from under the center console.
D. Find the best orientation for the speaker on your bar and screw
in the Set Screws in the OPPOSITE holes of where the clamp will
install into using a 4mm allen wrench
D