SSV Works GN-5A, Manual

Page: 7 / 28

7
Q1
OUTSIDE DASH VIEW INSIDE DASH VIEW
S
U2
Q2
U1
T
Q. Remove the two (2) T30 torx screws and clips located at the bottom of the dash panel near the center console
L. Unclip harness that runs along top cross bar of dash (holes will
be used to mount amp and sub plate).
U. Once amp plate is laying flat on the cross bar use two (2) M5 Screws and M5 washers pass through the top holes. From underneath use two (2) washers and
two (2) M5 nuts and secure the Amp plate down into position. (you will need 8mm socket and T25 torx screwdriver) .
T. Insert the loaded amp plate into the center of the dash from the top.
AMP PLATE INSTALLATION