SSV Works GN-3A, Installation Instructions Manual, Page: 6 / 25

6
J
RUNNING AMP POWER CABLE & SPEAKER WIRE
L
P
K
O
M
J. Unplug the rubber grommet located on the firewall.
L. Feed power/ground and H1150 harness down towards the center
console until you get the wires to the inside of the vehicle.
P. Feed each side of the H1149 harness down through the open cavity
on top of the dash towards the driver and passenger footwell.
K. Unwrap the tape from rubber grommet and feed the power/ground
wire for the Amp through the grommet as well as the rear speaker
harness H1151.
O. Route the H1149 harness towards the driver and passenger side of
the dash.
M. Follow the air ducts and factory wiring and feed cables towards the
back. (use provided zip ties to secure cables to factory wiring, away
from the drive shaft).