SSV Works GN-3A, Installation Instructions Manual, Page: 23 / 25

23
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: 818-991-1778 | Fax: 866-293-6751
Polaris General
USB/AUX Input Port
A
C
E G
B
D
A. Unscrew and remove the plastic nut from the port. Make sure to
open the fuse holder and remove the fuse so the nut will fit through it.
Crimp on the provided ring terminals on the ends of the (Red) Power
and (Black) Ground wire.
C. Feed in the wires and cable through the factory 12v hole. Keep the
fuse holder open and empty until it has passed through the hole.
E. Connect the AUX-in connector to the MRB3 brain G. Run the (RED) Power and (BLACK) Ground wire of the USB/Aux input
port to the Bus Bar. Unscrew the nut on the first position terminal
(accessory) and attach the (RED) Power wire. Refasten the nut. Then
unscrew the nut on the second position terminal and attach the (BLACK)
Ground wire. Refasten the nut.
B. Make sure all harness connectors are unplugged from the dash
panel. Push out the factory 12v port.
D. Feed the plastic nut back through the wires and cables and
screw back on to the port. Hand tighten only. Replace fuse and
close fuse holder.