www.sstcomm.com
51
Note:
In the software, all the gray parts cannot be changed.
Work mode: The first combo box in Parameters Configuration session is to set work mode.
Use UART setting mode: when you choose it, “IP configuration mode”, “IP address”, “Subnet mask”,
“Gateway address” can be changed. When you choose “UART setting mode” in embedded configuration interface,
you must choose the mode here.
IP configuration mode: Static configuration mode, DHCP, and BOOTP can be selected.
If you don’t choose one, “IP configuration mode”, “IP address”, “Subnet mask”, “Gateway address” cannot
be changed, and you can configure IP address and so on through configuration software SST-EMT-CFG.
Input-data bytes, Output-data bytes: The value must be same with the input and output data bytes of Modbus
TCP set in the embedded configuration interface.
9.3 Establish/Disconnect Connection
Data in the Parameters Configuration section has default value, and you can input the value you need and
click “Run”. There will pop up a dialog box to configure serial port:
Data Receiving section: To
display the data received.
Data Transmitting section: To
display the data need to be sent.
Parameters Configuration section: To
configure the parameters.
