- 7 -
There
are
two
types,
three-position
as
showed
in
following sketches, to be used for
different models.
"
" (OFF) position
All circuits are disconnected
and the key can be removed.
"
" (ON) position
All igniting circuits are ON and
the engine can be started. The key
cannot be removed in this position.
“
” (Parking) Position (FIG1)
To park the motorcycle, turn
the key to “ ” position. In this
position, the key can be removed
and the tail lamps (parking lamps)
and front positioning lamps stay
ON for parking on the roadside at
night.
WARNING
Before turning the key to “
”
position, park the vehicle with its
side stand or central stand down.
“
“ Position (FIG2)
In
order
to
lock
the
handlebars, turn the bar to the left,
then insert the key. Rotate it
clockwise to full stop for locking
the handlebars.
WARNING
If the handlebars are locked, the
motorcycle should not be ridden;
otherwise you will lose balance.
Left handlebar control system
Clutch Lever
①
To start the engine or shift gears,
pull in the lever to release the
drive system and cut off the
clutch.
Dimmer Switch
②
When dimmer switch is turned
up to "
" (high beam) position,
the head light is in high beam and
the high beam indicator lamp on
the instrument panel is lit. On the
contrary, when it is turned down
to "
" (low beam) position, the
low beam is lit.
Turn signal operation. When the
switch is turned to left "
"
position, the left turn signal lamp
is lit and the indicator lamp on
instrument panel flashes. When
the switch is turned to right "
" position, the right turn signal
lamp is lit and the indicator lamp
on instrument panel flashes.
Warning:
Whenever you are going to
change lanes or make a turn,
