26
• Headlight Adjustment
The headlight beam can
be adjusted vertically.
The adjustment bolts
(1) are located on both
sides of the headlight
bucket. Using a 13mm
wrench loosen both side
bolts (1) and adjust the
beam to the desired position, then tighten the
bolts.
• Bulb Replacement
When replacing a blown/broken bulb be sure
to use a bulb of the same wattage. A bulb
of higher wattage can cause melting of the
bulb, lens, or electrical faults.
Headlight Parking Lamp Replacement
1. Remove the two
bolts (1) as in the
picture.
2. Move the rubber dust boot back to expose
the bulb.
3. Unclip the head-
light bulb (1) and
replace with a 12V
35/35W bulb.
4. Replace the
parking lamp bulb
(2) by pulling it.
• Taillamp Bulb Replacement
1. Remove the two bolts securing the taillight
lens.
2. Push the bulb in and rotate it left to re-
move it from the base.
3. Install a new bulb by pressing in and turn-
ing it to the right.
Caution:
When adjusting the beam, the rider should
sit on the seat and keep the moped in a
vertical position.
Summary of Contents for Lazer5
