SRT VIPER KT1108TG, Owner'S Manual

Page: 10 / 26

First charge 24 hours. Do not charge more than 30 hours
Normal charge 8-16 hours. Do not charge for more than 24 hours
Note: You will only need to connect the battery to the motor one time,
unless you are removing the battery. See page 19 for battery removal.
1. Attach the red wire connectors located in the seat well, next to
the battery.
2. Store the wires and connectors down next to the battery.
Charge the Battery
3. Flip the battery charger port cap down (located on the right, rear side
of the car).
4. Insert the battery charger connector into the charger port.
5. Plug the
charger into a standard 120V wall outlet.
Note: The charger may feel warm during charging. This is normal and
not a cause for concern.
6. After charging is complete unplug the charger from the wall outlet and
unplug the battery connector from the charging port.
Tip!
10
Connect the Battery
The battery can be charged at any time during the assembly
process; however, it’s best to do it at this time since you will be
installing the car seat over the battery. The table below shows the
time needed for charging the KidTrax 6 volt battery.