( 3 / 4)
Controls and indication
Device use/servicing:
By default, without any incoming signal, all LEDs are off and the Power ON LED
indicates the device is on main power. When there is no Power ON sign, check
main power input or fuses on the main board.
When you connect the DMX cable to device, LEDs marked as D+ and D- go ON
for side marked as > and this indicates that DSR10IP is receiving the DMX signal.
Speed of light on these LEDs also indicates the refresh rate of DMX signal. Fast
blinking – high refresh rate, slow blinking – slow refresh rate.
Now the DSR10IP is fully working and retransmitting the input to the optically
isolated outputs. If any of data LEDs is off, unplug the signal cable
corresponding to this output and check the cable for short circuit between D+
and CMN or D- and CMD lines.
In case of problems do not hesitate to contact us at
or
+421244681417 and stay calm. We will help you fix your problems for sure.
